🔗 Radio & Intercom Dash Mounts

Fits Polaris RZR Pro R, Pro XP, and Turbo R (2020–2024). Includes Low Pro, XL, and Carbon Fiber variants for PCI Kenwood, PCI ICOM, and Rugged Radios M1.

• Remove the factory lower dash panel (2 screws)
• Slide the Diamond Performance dash plate into the factory mounting location
• Secure with the included stainless steel hardware
• Mount your radio using the included radio-specific brackets and tabs
• Route cables through the factory cable management channels
• Reinstall any factory switch panels if using a Low Pro mount

⚠ Does not fit 2025 Polaris RZR Pro R — Polaris changed the dash design that year.

💧 Multi-Chambered Catch Cans

Available for Polaris RZR Pro XP, Turbo R, Turbo/S, and Can-Am Maverick X3. 100% bolt-on clamp-on design — installs in under 30 minutes.

• Locate the factory PCV hose on your engine (refer to your model’s service manual for exact location)
• Disconnect the factory PCV hose from the intake
• Connect the catch can inlet hose to the factory PCV hose using the included clamp
• Cap the factory charge tube port with the included 3/4" rubber cap
• Mount the catch can body using the included hose clamps to a secure location in the engine bay
• Ensure the catch can is upright and secure before running the engine
• Check the reservoir after the first ride and drain as needed

💡 Tip: Check and drain the catch can every 5–10 hours of riding, more frequently on tuned or high-mileage engines.

🔧 Baja Engine Access Panel

Available for Polaris RZR Pro R (all years) and Pro XP / Turbo R / Pro S (all years). Installs in under 2 hours with basic hand tools.

• Remove the factory bed section where the hatch will be installed (refer to your model’s service manual)
• Mark and trim the hatch opening area using the included template
• Test fit the panel assembly before final installation
• Secure the panel frame using the included mounting hardware
• Install the rubber-insulated hatch door onto the frame
• Test the push-latch mechanism — it should open and close smoothly with no tools
• Reinstall the remaining factory bed sections around the panel

⚠ Pro R and Pro XP/Turbo R panels are NOT interchangeable — the bed designs are different. Order the correct version for your model.

💡 Martian LED Whips

Universal mount — compatible with most UTV flag/whip mounts.

• Thread the whip base into your existing flag/whip mount
• Route the power wire to your switch panel or fuse block
• Connect the positive wire to a switched 12V source and ground to chassis
• Use the included controller to set your preferred light pattern

Need Help With Your Install?

We offer professional installation at our Mission Viejo, CA shop. Drop off your machine and we’ll handle everything.